Skip to content

How do I sew a mitered corner?

A mitered corner meets two hems at a diagonal. It lies flat, with no bulky overlap, and gives a professional finish.

Where to use it

  • Napkins, tablecloths, curtains and blankets.
  • Quilt bindings.
  • Jacket vents and front corners.

Method 1: the sewn miter

For double-fold hems on napkins and curtains:

  1. Press both hems up to their finished depth, including the small turn-under — see how to sew a hem.
  2. Unfold them. The crease lines cross at the corner.
  3. Fold the corner in diagonally, through the point where the inner fold lines cross. Press.
  4. Unfold the corner and fold the fabric right sides together, matching the edges, so the diagonal crease forms a straight line.
  5. Sew along the diagonal crease.
  6. Trim the seam to about 1/4 inch, and cut across the point.
  7. Press the seam open, turn the corner right side out, push out the point gently, and press the hems back.
  8. Stitch the hems.

Method 2: the folded miter

Quicker, not sewn:

  1. Press both hems.
  2. Fold the corner in diagonally and press.
  3. Fold the hems back over it; the edges meet in a diagonal.
  4. Stitch the hems, then slipstitch the diagonal by hand if needed.

Mitering a binding

For quilts:

  1. Sew the binding to within the seam allowance of the corner; backstitch.
  2. Fold the binding up at 45 degrees, then back down along the next edge, aligning the fold with the previous edge.
  3. Continue sewing.
  4. When turned, the corner forms a miter on both sides.

Equal depths

For a 45-degree miter, both hems must be the same depth. Different depths give an angled miter, which works but needs careful marking.

Tools

A seam gauge for even folds and a point turner for corners. Wonder Clips hold folds without pins.

Common problems

  • Bulky corner: trim more.
  • Gap at the point: sew slightly past the fold line.
  • Uneven miter: hems pressed to different depths.

See how to sew a neat corner and pressing versus ironing.

What sewers ask us

Where are mitered corners used?

Napkins, tablecloths, curtains, blanket edges, quilt bindings and the vents and corners of jackets.

Do both hems need the same depth?

For a 45-degree miter, yes. Different depths give an angled miter, which needs careful marking.

Can I miter a binding?

Yes. Quilt bindings are mitered by folding the binding up and back at each corner as you sew it.

How do I get a sharp point?

Trim close to the stitching across the point, and push it out gently with a point turner.

Last reviewed