Only if your serger is designed for them, and you cannot tell by looking. Many domestic sergers (overlockers) take ordinary 130/705 H sewing machine needles. Others need ELx705, and some older or semi-industrial machines take a round-shank industrial needle.
Check the manual
This is one of the few needle questions with no general answer, and guessing has consequences. A needle of the wrong length sits at the wrong height relative to the loopers. That gives skipped stitches at best and a needle striking the looper at worst — and a damaged looper is an expensive repair. The needle system is also usually printed on the accessory box or inside the front cover.
What ELx705 adds
An ELx705 needle has a second scarf — the shaped hollow above the eye — and a slightly different eye and shank finish. On a serger, the upper and lower loopers approach the needle from different directions, and the extra clearance improves loop pickup. On a machine specified for ELx705, an ordinary needle may work, but it usually skips more, especially on knits. ELx705 needles are also common on coverstitch machines.
Sizes
- 75/11 for fine knits and lightweight fabric,
- 80/12 for general use,
- 90/14 for heavier fabric such as sweatshirting or denim.
Ballpoint versions suit knits, which is most serging. Our sewing machine needles page and serger parts page list the packs we checked.
Change them often
A serger runs fast and blunts needles quickly. A great many serger faults blamed on threading are simply a blunt needle. Before rethreading all four threads, fit fresh needles — see why a serger skips stitches.
Insert them correctly
On a four-thread serger the two needles often sit at slightly different heights, with the left needle a little higher than the right. Push each one fully up into its own position, flat side facing the way the manual shows, and tighten each clamp screw. A needle that is not fully up is the commonest reason a fresh needle still skips. See how to change a serger needle.
Keep the right screwdriver
The needle clamp screws on most sergers are small and recessed. Use the small screwdriver or hex key supplied with the machine; a larger one slips and damages the screw head. Many sergers also come with a needle inserter that holds the needle straight while you tighten it.
Two needles, one type
Physically you can fit two different needles, but use a matched pair of the same type and size unless the manual says otherwise. Mixing sizes changes how each needle’s loop meets the loopers. If you are choosing a machine, our sergers page lists the needle system each one states.
What sewers ask us
Can I fit two different needle types?
Physically yes, and it is a bad idea. Use a matched pair of the same type and size unless the manual says otherwise.
My serger skips on knits.
Fit fresh ballpoint needles of the correct system first. That fixes it far more often than rethreading does.
How often should I change serger needles?
More often than on a sewing machine, because a serger runs fast. Every few garments on knits, or at the first skipped stitch, is a reasonable habit.
Can I use a stretch needle in a serger?
If your serger takes 130/705 H needles, a stretch or ballpoint 130/705 H needle works for knits. If it takes ELx705, use ELx705 needles in their ballpoint or SUK version.
Last reviewed