Skip to content

How do I change a serger needle?

Changing a serger needle is like changing a sewing machine needle, with two differences: there are two needle positions, and they are not at the same height.

Check the needle type

  • Many home sergers, including the Brother 1034D, use standard 130/705 H needles.
  • Others, and many coverstitch machines, use ELx705 needles, such as the Schmetz ELx705.
  • Some industrial-style sergers use other systems.

The manual, or the needle pack supplied with the serger, tells you. Using the wrong type is a common cause of skipped stitches — see can I use machine needles in a serger.

Before you start

  1. Turn the handwheel toward you until the needles are at their highest point.
  2. Switch off and unplug the serger.
  3. Lower the presser foot, or put a scrap under it, so a needle cannot drop into the machine.

Change one needle at a time

  1. Find the screw for the needle you are changing — each needle usually has its own screw.
  2. Loosen it with the small hex key supplied, turning it a little — do not remove it.
  3. Pull the needle down and out.
  4. Insert the new needle with the flat side to the back.
  5. Push it fully up into its slot until it stops.
  6. Tighten the screw firmly.

Then change the other one.

Why the needles are at different heights

On many sergers, the right needle sits slightly lower than the left. This is by design: each needle meets the looper at a slightly different moment. If both are pushed fully up into their slots, they sit at the correct heights automatically.

Rethread

Rethread the needles — on most sergers, the needles are threaded after the loopers. See how to thread a serger.

Test

Serge a test seam on a scrap. If a needle thread skips or breaks, check that the needle is fully up and facing the right way.

When to change serger needles

  • After several hours of serging.
  • Immediately after hitting a pin — never serge over pins, since the knife can be damaged too.
  • When stitches skip or thread frays.
  • When moving to knits or very fine fabric, a fresh needle of the right type helps.

3-thread stitches

For a 3-thread stitch, you use only one needle: the left for a wide stitch, the right for a narrow one. Remove the other needle, or leave it unthreaded if the manual says so.

Keep track

Write the date of the last needle change on the serger’s needle box. More maintenance: looking after a serger and serger parts.

What sewers ask us

Do sergers use regular sewing machine needles?

Many home sergers use standard 130/705 H needles; some use ELx705 or other types. The manual or the needle case supplied with the serger tells you.

Why does one needle sit lower than the other?

On many sergers the right needle is set slightly lower by design, so each needle meets the looper at the right moment. Pushing both fully up in their slots puts them at the correct heights.

Should I change both needles at once?

Usually yes, since they wear at the same rate. Change them one at a time so you do not mix up positions.

Why does my serger skip stitches after a needle change?

The needle is not fully up, is turned, or is the wrong type. Reinsert it and check the manual.

Last reviewed