Skip to content

How do I thread a serger without losing my mind?

Threading a serger is about order. Follow the manual’s sequence and seat each thread in its disc.

Before you start

  • Raise the presser foot, which opens the tension discs.
  • Turn the handwheel to the position the manual shows, often with the needles up.
  • Open the front cover.
  • Have tweezers ready.

The usual order

On many four-thread sergers:

  1. Upper looper.
  2. Lower looper.
  3. Right needle.
  4. Left needle.

Always check your manual: the loopers come before the needles because the needle threads must pass over them.

Follow the colors

Most sergers have color-coded guides: one color per thread path. Follow each path guide by guide, and floss the thread firmly into its tension disc.

The lower looper

The hardest step. Many sergers have a lower looper threader — a lever that brings the looper eye forward. The Brother 1034D has one.

Test

Close the cover, lower the foot, hold the threads behind the foot and turn the handwheel. Serge a chain, then a scrap — see how to set serger tension.

The tie-on method

To change colors without rethreading:

  1. Cut each thread near its spool.
  2. Tie the new thread on with a small square knot.
  3. Raise the presser foot.
  4. Pull the threads through gently, one at a time, until the knots pass the guides. Pull needle threads only to just before the eye, then cut and thread the needle.

When a looper thread breaks

Unthread the needles first, rethread the looper, then rethread the needles.

Common problems

  • Threads breaking: not in the tension discs, or out of order.
  • No stitch forming: a looper missed.
  • Loops on the edge: looper tension; check threading first.

Make it easier

Keep the manual’s threading diagram next to the serger, and photograph each path the first time. With practice, threading takes a few minutes.

See looking after a serger and our sergers page.

What sewers ask us

In what order do I thread a serger?

Usually upper looper, lower looper, right needle, left needle — but always check your manual.

Why does my serger break threads after threading?

A thread is outside its tension disc or a looper was threaded out of order. Rethread with the foot raised.

What is the tie-on method?

Cutting the old threads at the spool, tying the new ones on and pulling the knots through the guides.

Do some sergers thread themselves?

Some have air threading or a lower looper threader, such as the Brother 1034D, which makes the hardest step easier.

Last reviewed