Skip to content

How do I unpick a serged seam?

A serged seam unpicks quickly if you pull the right threads: the needle threads.

Understand the stitch

A four-thread serged seam has:

  • Two needle threads — the straight lines on the top.
  • Two looper threads — the loops wrapping the edge.

The needle threads lock the loopers. Remove them and the loopers fall away.

Step by step

  1. At one end of the seam, free the thread chain or clip it close to the fabric.
  2. With a pin or seam ripper, pick out one needle thread — the left or right straight line.
  3. Pull it gently along the seam. It slides out like a drawstring, gathering slightly.
  4. Pull the second needle thread the same way.
  5. The looper threads are now loose: lift them off the edge.

If a needle thread breaks, pick it out again a little further along and continue.

Cutting it off

If the seam allowance is wide enough for the new seam, simply cut the serged edge off with scissors or a rotary cutter. This is fastest, but the piece becomes slightly smaller.

Secured ends

If the chain was woven back or sealed, cut a few stitches at the end first — see how to secure a serged seam end.

Three-thread seams

Pull the single needle thread; the loopers come free.

Rolled hems

Pull the needle thread of a rolled hem the same way. The edge underneath may be slightly chewed; trim it.

After unpicking

Remove fragments with tape, press, and check that the fabric edge is still intact before reserging.

Prevention

Baste or pin-fit seams before serging; serging trims the edge, so mistakes cost seam allowance — see when should I serge a seam.

Tools

A seam ripper and a pin are all you need.

Common problems

  • Thread will not slide: clip the end free, or pull from the other end.
  • Fabric cut: used the ripper between layers.

See how to unpick a seam and our sergers page.

What sewers ask us

Which thread do I pull to undo serging?

The needle threads — the straight lines on top. Once they are out, the looper threads fall away.

Can I just cut off a serged seam?

Yes, if there is enough seam allowance left for the new seam.

Why will the needle thread not slide out?

The end is caught or knotted. Clip it free, and pull from the other end.

Can I reuse the thread?

Usually not; it is short and kinked. Use fresh thread.

Last reviewed