Skip to content

How do I set serger tension?

Serger tension is easier to set when each thread is a different color. You can then see which dial to change.

Start at default

Set every tension dial to its default mark, usually around 4. Check the threading first — most problems are threading — see how to thread a serger.

Use four colors

Thread each position with a different color: left needle, right needle, upper looper, lower looper. Serge a test on a scrap of the real fabric, about 6 inches long, on the lengthwise grain.

Read a balanced stitch

  • Upper looper thread lies on top of the fabric.
  • Lower looper thread lies on the underside.
  • The two loopers meet exactly at the fabric edge.
  • Needle threads lie flat in a straight line, with no loops on the underside.

Fix what you see

Upper looper pulled to the underside: upper looper too loose, or lower looper too tight — tighten the upper or loosen the lower.

Lower looper pulled to the top: lower looper too loose, or upper too tight — tighten the lower or loosen the upper.

Loopers meet beyond the edge, loops hanging: both loopers too loose — tighten both slightly.

Edge curls or puckers: loopers too tight — loosen both slightly.

Needle thread loops underneath: that needle’s tension too loose — tighten it.

Seam pulls apart into a ladder when stretched: left needle too loose — tighten it. See why does my serged seam pull apart.

Change one dial at a time

Turn one dial by about half a number, test, and look again. Changing several at once makes it impossible to tell what worked.

Stitch width and length

If the loopers cannot meet at the edge, check the cutting width — the knife may be cutting too much or too little. Lengthen the stitch on thick fabric — see how to serge thick fabric.

Different fabrics

Knits often need slightly looser tensions; fine fabrics a looser needle — see how to serge fine or sheer fabric.

Keep a record

Note the settings for each fabric on a card. Our sergers page lists models with color-coded threading, such as the Brother 1034D.

For the rolled hem settings, see how to do a rolled hem on a serger.

What sewers ask us

How do I know which thread is wrong?

Use a different color in each position. The color in the wrong place shows which dial to change.

What should a balanced serger stitch look like?

The upper looper on top, the lower looper underneath, meeting at the edge; needle threads flat, with no loops.

Should I change several dials at once?

No. Change one at a time, by about half a number, and test.

Why does tension change between fabrics?

Thickness, stretch and weave change how the threads sit. Test on each new fabric.

Last reviewed