Skip to content

How do I serge thick or bulky fabric?

Thick fabric needs a longer, wider stitch and a slower pace. A home serger handles medium-heavy fabric well, within limits.

Needle

Fit a larger needle in your serger’s type — around 90/14. See how to change a serger needle.

Stitch

  • Longer: around 3–4 mm.
  • Wider: the maximum width, using both needles for a 4-thread stitch.

A short, narrow stitch piles up and does not cover the edge.

Tension

Loosen the looper tensions slightly so they wrap the thicker edge without pulling it. Adjust one at a time — see how to set serger tension.

Differential feed

Thick knits such as fleece and sweatshirt fabric stretch into waves. Set the differential feed above 1 — around 1.3 to 1.5 — so the front feed dogs push more fabric under the foot. See what is differential feed.

Presser foot pressure

If your serger has adjustable pressure, lower it slightly for thick fabric.

Speed

Serge slowly, especially at seam crossings. Turn the handwheel by hand over the thickest parts.

Reduce bulk

  • Trim the seam allowance close to the cutting line before serging, so the knife has less to cut.
  • Flatten seam crossings with a hammer or press.
  • Grade seams where several layers meet — see how to grade a seam allowance.

Limits

Home sergers have limits:

  • Two layers of medium denim: usually fine.
  • Many layers or heavy canvas: may exceed the knife and feed.
  • Flat-felled jeans seams: use a sewing machine instead.

If the knife struggles, sew the seam on a heavy-duty sewing machine and finish the edge with a zigzag.

Fabrics

  • Fleece: differential feed above 1, longer stitch.
  • Denim: larger needle, slow speed.
  • Boiled wool and coating: trim first.
  • Sweater knits: differential feed above 1.

Start and end carefully

Thick fabric is hard to start under the foot. Lift the presser foot and slide the fabric in up to the knife, lower it, and start slowly. At the end, serge off the fabric onto a chain rather than stopping on the edge.

Keep it clean

Thick fabrics, especially fleece, fill the knife area with lint quickly. Brush it out often — see how to clean and oil a serger.

Common problems

  • Waves: differential feed higher.
  • Edge not covered: longer stitch, looser loopers.
  • Skipped stitches: larger needle.
  • Knife jamming: too thick; trim first.

See how to serge fine or sheer fabric and our sergers page.

What sewers ask us

Can a home serger handle denim?

Two layers of medium denim, usually yes. Many layers, flat-felled seams or heavy canvas may exceed the knife and feed.

Why do my serger stitches not cover thick fabric?

The stitch is too short or the looper tension too tight. Lengthen the stitch and loosen the loopers.

What does differential feed do on thick fabric?

Above 1, it pushes more fabric under the foot, which prevents thick knits such as fleece stretching into waves.

Should I trim before serging?

Yes, on very thick fabric. It reduces the load on the knife.

Last reviewed