A serger trims fabric as it sews, so it fills with lint far faster than a sewing machine. Regular cleaning keeps stitches even and the knives sharp.
What you need
- A lint brush — usually supplied; a pair of lint brushes reaches further.
- Sewing machine oil, with a precision oiler.
- A soft cloth.
- Tweezers for threads caught in the loopers.
Step by step
- Unplug the serger.
- Remove the thread or leave it, as you prefer. Cut the threads above the needles if they get in the way.
- Open the front cover and the side cover, if it has one.
- Remove the trim bin and empty it.
- Brush out the lint from around the loopers, knives, feed dogs and needle plate. Work from the inside out.
- Lower the upper knife, if your serger allows, to reach underneath.
- Wipe away old oil and lint with a cloth.
- Oil only the marked points, one drop each — see the manual. Some sergers mark them in red.
- Run the serger for a few seconds without thread.
- Close the covers and serge on a scrap until no oil appears.
What not to do
- Do not blow into it — breath contains moisture.
- Avoid canned air, which pushes lint deeper.
- Do not over-oil; excess oil stains fabric.
- Do not use household oil — see sewing machine oiling.
How often
- Brush it after every project.
- Oil it as the manual says, often after several hours of serging.
- Clean more often with fleece, flannel and terry, which produce a lot of lint.
Check while cleaning
- Needles: change them if they are old — see how to change a serger needle.
- Knives: a chewed edge means the upper knife needs replacing — see how to replace a serger blade.
- Loopers: check for threads wrapped around them.
Rethreading
If you removed the threads, rethread in the manual’s order — see how to thread a serger.
Professional service
If a clean, oiled serger still skips stitches or sounds rough, take it to a dealer. Machines such as the Juki MO-654DE and Brother 1034D are worth servicing.
More
See looking after a serger for needles, knives and storage, and our machine maintenance page for oils and brushes we checked.
What sewers ask us
How often should I clean my serger?
After every project, and during long projects on lint-heavy fabrics such as fleece.
Where do I oil a serger?
At the points marked in the manual, often around the loopers and needle bar. Some sergers have oiling points marked in red.
Can I use canned air?
Many manufacturers advise against it, because it pushes lint deeper into the mechanism.
What oil should I use?
Clear sewing machine oil only. Never household oils or sprays.
Last reviewed