Skip to content

How do I serge a curve or a corner?

Curves and corners are about guiding the fabric in front of the knife. The serger cuts before it stitches, so steer the cut edge, not the needle.

Curves

  1. Sew slowly.
  2. Watch the knife, not the needle.
  3. Turn the fabric gradually, a little at a time, keeping the edge feeding into the knife.
  4. On tight curves, stop often with the needle down, lift the foot slightly, and adjust.

Trim a little as you go, so the knife cuts a clean edge all the way around.

Outside corners

Method 1: serge off and start again

  1. Serge to the end of the first side and off the fabric.
  2. Turn the fabric and serge the next side, starting at the edge.
  3. Secure the chains — see how to secure a serged seam end.

Method 2: the notch and pivot

  1. Before serging, cut a small notch at the corner, the width of the stitch, along the second side.
  2. Serge to the corner.
  3. Stop with the needle in the fabric, lift the presser foot, pull a little slack in the threads, and turn the fabric.
  4. Lower the foot and continue along the notched edge.

Inside corners

  1. Serge up to the corner.
  2. Pull the fabric so the two sides form a straight line in front of the knife — the corner folds into pleats behind it.
  3. Serge across.
  4. Let the fabric relax: the corner returns.

Staystitch or clip inside corners first if the fabric is fragile.

Circles

On a closed circle, serge over the starting stitches by about 1 inch, then swing the knife out of the way or lift the foot, and chain off.

Rolled hems on curves

Curved rolled hems — scarf corners, napkins — follow the same rules, more slowly — see how to do a rolled hem on a serger.

Common problems

  • Uneven edge: turning too fast.
  • Stitches falling off the edge: fabric pulled away from the knife.
  • Chewed corner: a dull knife — see how to replace a serger blade.

Practice

Practice on scrap: a circle, an outside corner and an inside corner. It takes a few tries.

Our sergers page compares the models we checked.

What sewers ask us

Should I watch the needle or the knife?

The knife. The serger cuts before it stitches, so guiding the cut edge is what keeps the line accurate.

How do I serge an outside corner?

Serge off the edge and start the next side, or cut a small notch at the corner and pivot with the needle in the fabric.

How do I serge an inside corner?

Straighten the corner in front of the knife by pulling the fabric into a line, serge it, then let it relax.

Can I serge a circle?

Yes. Overlap the starting stitches by about an inch, then move the knife out of the way and chain off.

Last reviewed