Skip to content

Why is my serger skipping stitches?

Start with the needle. Most serger skipped stitches are needle problems.

1. The needle

  • New and straight.
  • The right type for your serger — standard 130/705 H or ELx705 — see can I use machine needles in a serger.
  • Fully up in its slot; on many sergers the right needle sits slightly lower by design.

See how to change a serger needle.

2. Threading

  • Thread in the manual’s order — usually upper looper, lower looper, right needle, left needle.
  • Each thread seated in its tension disc.
  • Presser foot raised while threading.

See how to thread a serger.

3. Knits

On knits, a ballpoint or stretch needle in your serger’s system stops skipped stitches.

4. Thread

Use good serger thread on cones. Cheap or old thread skips and breaks — see do I need special thread for a serger.

5. Fabric

6. Tension

Extreme tension settings can skip. Return to defaults and rebalance — see how to set serger tension.

7. Lint

Clean the looper area — see how to clean and oil a serger.

8. Timing

If skipping continues with all of the above correct, a looper may be out of timing, often after a needle hit it. Take it to a dealer.

Speed

Sergers run fast; at top speed, a marginal needle or threading problem shows as skips. Serge a test seam slowly: if the skips disappear, the setup is borderline and a fresh needle or rethreading usually fixes it.

Seam crossings

Skips often appear where the serger climbs over a seam. Flatten the seam first and slow down; on very thick crossings, guide the fabric by hand without pulling.

Which thread skips

Notice which line skips: a missing needle line points to that needle; a gap in looper coverage points to a looper’s threading or tension.

See looking after a serger.

What sewers ask us

What is the first thing to check?

The needle: new, the right type for the serger, and pushed fully up.

Does threading order matter?

Yes. Loopers are threaded before needles on most sergers.

Why does it skip on knits?

The needle type. Use a ballpoint or stretch needle in the system your serger takes.

When is it a timing problem?

When skipping continues with a new needle, correct threading and good thread.

Last reviewed