Skip to content

Do I need special thread for a serger?

You do not need a different type of thread for construction, but you do need it in a different format and quantity.

Cones, not spools

A serger uses three, four or five threads at once and sews fast, so it consumes thread several times faster than a sewing machine. Cones of roughly 1,000 to 3,000 yards each are the normal format, and buying cones in sets of four — one per thread — is a realistic purchase rather than an extravagant one. Our sewing threads page lists the cone sets we checked.

Ordinary polyester is fine

For general serging, a spun polyester serger thread works on wovens and knits alike. Serger thread is often slightly finer than sewing machine thread, which reduces bulk in a four-thread seam, but it is not a different material. All-purpose sewing thread also works for a one-off.

Textured (woolly) nylon belongs in the loopers

Textured nylon is a crimped thread that spreads out to cover the fabric edge completely, giving a soft seam that does not scratch against skin and that stretches with the fabric. Use it for:

Put it in the loopers only. In the needles it gives a weak, spongy seam, and it is the commonest threading mistake on a new serger. Thread it with a looper threader, because it is hard to push through the guides.

Keep the thread feeding smoothly

  • Use cone holders or the cone adapters supplied with the machine.
  • Fit a thread net over cones that unwind too freely; thread that spills off the cone tangles around the spindle and snaps mid-seam.
  • If you use ordinary spools, fit spool caps so the thread unwinds over the end and does not catch on the notch.

Match color approximately

In a four-thread seam the loopers barely show on the right side, so a near match in the loopers with an exact match on the needles is standard practice. It saves buying four cones per project.

Specialty threads

Decorative threads such as heavy rayon, metallic or pearl cotton can go in the upper looper for decorative edges and flatlocking, with a lower looper tension adjustment. They are not for the needles.

When thread is not the problem

If a serger skips or breaks thread, check the needles and the threading order before blaming the thread — see why a serger skips stitches and how to thread a serger. Machines and parts are on our sergers and serger parts pages.

What sewers ask us

Can I use sewing machine spools on a serger?

Yes, with spool caps or a cone holder, and you will run out quickly. Fine for a one-off in an unusual color.

Is woolly nylon necessary?

For rolled hems, close to essential — it is what gives the dense coverage. For ordinary seams it is a comfort improvement rather than a requirement.

How many cones do I need to start?

Four cones of one neutral color — white, black, gray or beige — cover a four-thread serger. Many sewers buy a set of four in each of three or four basic colors.

Do I need to match serger thread exactly to the fabric?

The needle threads show most. A close match in the needles with a neutral in the loopers is standard practice and saves buying a full set per project.

Last reviewed