Skip to content

Can I serge without cutting the fabric?

Yes, and there are two ways to do it. A serger (also called an overlocker) trims the edge as it stitches, but the knife is not compulsory.

Method 1: disengage the upper knife

Most sergers have a lever, knob or dial that swings the upper knife down out of the way. Check the manual first: the mechanism varies between brands, and forcing it is a good way to knock the blade out of alignment with the lower knife. Turn the machine off before you move the knife, and remember to re-engage it afterwards.

Method 2: guide the fabric clear of the knife

Feed the fabric so its edge runs just to the left of the blade, so nothing is trimmed. This works, but it needs attention: a moment of inattention costs you the edge. It is best kept for short runs.

When you want to serge without cutting

  • An edge already cut to size, where you only want the finish. Trimming would make the piece smaller than the pattern.
  • Curves, where the knife tends to shave more off the inside of the curve than you intended.
  • Applying elastic or binding, where the edge is being covered anyway and the knife could nick the elastic.
  • Flatlocking and decorative edges on a fold.
  • Anywhere a mistake is expensive. The knife is unforgiving, and there is no undo.

When you should let it cut

For ordinary seam construction, a freshly trimmed edge is exactly what makes a serged seam neat. The knife gives the loopers a clean, consistent edge to wrap; disengaging it on a hand-cut edge often produces a wavier finish with loops that hang off in some places and pull in others. On most seams, let the knife take off a sliver — about 1/8 inch — so the stitch forms on fresh fabric.

One caution

With the knife disengaged it is easy to feed too much fabric under the foot and serge a fold instead of an edge. Watch the stitch finger, not the needle, and keep the edge aligned with the knife line marked on the machine.

If your serger chews or frays the edge when the knife is engaged, the blade is usually dull or misaligned — see why a serger chews the edge and how to replace a serger blade. Replacement knives and other parts are on our serger parts page, and the machines themselves on sergers.

What sewers ask us

Does the blade wear out faster if I leave it engaged?

It wears with use, so yes, marginally. That is not a reason to disengage it — blades are consumables, like needles.

My edge is wavier without the blade.

Expected. A trimmed edge is more consistent than a hand-cut one, which is part of why a serged seam looks neat.

Is it safe to disengage the knife while the serger is threaded?

Yes on most machines, but turn the serger off first and follow the manual's sequence. Forcing the knife lever against the fabric is how blades get knocked out of alignment.

Can I serge a folded edge without cutting it?

That is how a flatlock or a decorative edge on a fold is made. Disengage the knife and let the fold ride along the knife line, but go slowly — it is easy to catch too much fabric.

Last reviewed