Skip to content

Why does my serger chew the fabric edge?

A chewed edge means the knives are not cutting cleanly.

1. Clean the knife area

Lint packed around the knives stops them meeting cleanly. Brush it out — see how to clean and oil a serger.

2. Check the knife is engaged

If the knife has been disengaged or swung out of the way, it does not cut — see can I serge without cutting.

3. Trim a little

Let the serger trim about 1/8 inch off the edge, so the knife cuts a fresh, straight edge. Feeding the fabric too far left means it does not cut.

4. Cutting width

If the cutting width is wrong for the stitch, the loopers wrap a ragged edge. Adjust it so the loopers meet at the cut edge — see how to set serger tension.

5. Needle

A dull needle drags the fabric. Fit a new one — see how to change a serger needle.

6. The knife

If the edge is still chewed, the upper knife is dull or nicked — often from hitting a pin. Replace it — see how to replace a serger blade.

7. Thick fabric

Very thick fabric can overwhelm the knife. Trim first and serge slowly — see how to serge thick fabric.

8. Feed

Guide the fabric straight in front of the knife; do not pull it sideways.

Fine fabric

Fine fabric can be pulled into the knife. Use a fresh needle, narrower stitch and tissue — see how to serge fine or sheer fabric.

Never serge over pins

One pin can nick a knife permanently. Pin away from the edge, or use clips.

Lower knife

The lower knife rarely needs replacing, but if the upper one is new and the edge is still chewed, ask a dealer to check the lower one.

See why is my serger not cutting properly.

What sewers ask us

How do I know the knife is dull?

The edge is chewed or not cut through, even with a clean knife area and a new needle.

Can lint cause chewing?

Yes. Packed lint stops the knives meeting cleanly.

Should I trim before serging?

Let the serger trim a little, about 1/8 inch, so the knife cuts a fresh edge.

Which knife wears first?

The moving upper knife on most home sergers.

Last reviewed