Skip to content

Can I serge woven fabric?

Yes, and finishing woven seam allowances is one of the things a serger (overlocker) does best. Most ready-to-wear woven shirts, pants and skirts are built exactly this way.

The usual method for wovens

  1. Sew the seam on your sewing machine with a straight stitch at the pattern’s seam allowance.
  2. Press it as sewn, then press the allowances to one side.
  3. Serge the raw edges together with a three-thread stitch, letting the knife trim a sliver so the stitch forms on fresh fabric.

That gives you an accurate, pressed seam with a neat, non-fraying edge.

Serging the edges before sewing

You can also serge each piece’s edges separately before sewing the seam. This suits seams that are pressed open — the side seams of tailored pants, the center back of a skirt with a zipper, a lined jacket — and it is the tidier option where the inside will be seen. Serge without trimming more than a sliver, or the seam allowance will shrink; see serging without cutting.

Should you construct woven seams on the serger directly?

Sometimes. It is quick, and it is fine on casual garments, pajamas and side seams that do not need pressing open. But you lose:

  • the pressed-open seam,
  • the ability to let a seam out later,
  • the chance to check the fit before the allowance has been trimmed away.

On anything fitted, sew first and serge after. See when to serge a seam for the full decision.

Settings for wovens

  • Stitch: three-thread for finishing; four-thread if the serger also sews the seam.
  • Needle: a universal or sharp needle in a size to suit the fabric, often 80/12.
  • Differential feed: neutral (1.0). Wovens do not stretch, so the differential adjustment that matters on knits does very little — see what differential feed is.
  • Stitch length: around 2.5 to 3 mm; shorter on fine fabric.

Fine and fraying fabric

On fine fabric, a narrower stitch or a rolled hem setting handles the edge better than a wide stitch, which can pull and show through. Our page on serging fine or sheer fabric has the settings.

Very loosely woven fabric

On loose weaves — some linens, bouclé, gauze — a serged edge can let the threads pull out of the stitch under strain. An enclosed finish holds better: see how to sew a French seam or a flat-felled seam.

No serger?

A zigzag or overcast stitch on a sewing machine finishes woven edges well enough for most garments — see finishing a seam without a serger. If you finish seams often, our sergers page compares the machines we checked.

What sewers ask us

Should I serge before or after sewing the seam?

After, for most garments — you can still adjust the fit. Before, when the seam will be pressed open and you want each allowance finished separately.

Does serging replace pinking?

It is considerably more durable. Pinked edges reduce fraying; a serged edge encloses it, and it survives washing far better.

Three-thread or four-thread for wovens?

Three-thread is enough to finish an edge and is lighter and flatter. Four-thread adds a second needle line for strength, which matters when the serger is also sewing the seam.

Which differential feed setting for wovens?

Neutral, 1.0, for most stable wovens. Wovens do not stretch, so differential feed matters little — except on bias edges and very loose weaves, where a slight increase stops the edge waving.

Last reviewed